I did have to cut the 25mm rods, but I can't remember how long they needed to be in order for me to run the camera and have my HDMI cable clear. It looks like the 15mm rods were 12" (I did not have to cut those). However, I do have links to the carbon rods I purchased a while back. Unfortunately, I not longer own this as I upgraded to the MoVI Pro. View attachment 13217 View attachment 13216 View attachment 13218 Replaced the 25mm aluminum rod that connects off the pan motor since I extended the roll -> tilt motor arms.Įither way, I was able to make it work with the camera build I listed, but the biggest challenge is getting enough weight in FRONT of the tilt motor since you can't slide the camera through the MoVI cage. Swap out the 25mm carbon rods that connect roll arm to tilt, which allowed me to have a bit more clearance between camera and roll arm. Replace the 15mm rods to allow me to use my baseplate with the cage I did modify my M5 to make it easier to balance and operate with the above camera package (not necessary). ![]() ![]() Below was my build for balancing the M5 with the Pocket 6K It took me a while to figure out how to balance with my 6K, but it DOES work. I operated with an M5 and Pocket 6K for about a year before upgrading to the MoVI Pro. I apologize for the super late response on here.
0 Comments
Leave a Reply. |